New Version: 2.1.14181 (2018 10 16)
|
11-01-2018, 01:04 PM
(This post was last modified: 11-01-2018 01:12 PM by rprosperi.)
Post: #3
|
|||
|
|||
RE: New Version: 2.1.14181 (2018 10 16)
Question about installing/upgrading the ConnKit. I am running Win-7 x64.
I had a 32-bit version of ConnKit installed, and used 'Check for Updates' - It downloaded the update and installed it with no problems (also updated my device without problems). But now when checking for updates, it detects the x64 version of ConnKit. So I tell it proceed, to update from x86 to x64. The x64 update downloads and starts, but then the installer halts with an error, saying another version is installed and I should correct the problem. Note the same upgrade process (from x86 version to x64 version) seemed to update fine for the Virtual Calculator. @Tim - Should I manually uninstall the x86 version of the ConnKit, and then manually run the x64 ConnKit installer? If so, will all the 'Content', Backups, etc. be preserved? Edit: FYI, I noticed on the ftp site, there is no .msi version of the x86 ConnKit, but all the others are there. --Bob Prosperi |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)