HP-65 more on the card reader
|
02-02-2019, 02:50 AM
Post: #32
|
|||
|
|||
RE: HP-65 more on the card reader
Now I hope I don't jinx what I accomplished by saying this but I think I finally got my HP65 card reader to work. After adjusting the eccentric cam for minimum current drain I replaced the original 5.11k ohm motor speed resistor with a pot and found the sweet spot to be 5.0k ohms. I assume a change was needed here because of the very slight difference in the diameter of the newly replaced pinch wheel from the original gummy wheel. I can read-in and execute per-programmed cards as well as record to blank cards and read/execute those too. I need to find a 5.0k 1% precision resistor to replace the temporary pot. I'm keeping my fingers crossed that this operational functionality lasts.
|
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)