Classic battery door latch 3d model?

[HP-Collection]

(09-10-2017 06:31 PM)mfleming Wrote:  

(09-09-2017 03:40 AM)Nate Martin Wrote:  I think I got these corrected and sent a sample today, I may still need to adjust length slightly but I did get it to snap in place. A couple of prices got wonky during all of my uploads, it was adding a markup which I did not intend to add during a scaling operation.

I still need to check the HP71 IL port cover for Sylvain, and I also uploaded a 41 extended module housing (https://www.shapeways.com/product/L99GKC4UW) today that i need to get a sample print.

What is the overall length of the extended module housing? Looks like there's room enough for an IR diode or, dare I say, GPS module

~Mark

I hope for a FM Radio module (remember the april's joke?)