+- HP Forums (https://www.hpmuseum.org/forum)
+-- Forum: HP Calculators (and very old HP Computers) (/forum-3.html)
+--- Forum: General Forum (/forum-4.html)
+--- Thread: Hp25c (/thread-10947.html)
Hp25c - dm123 - 06-20-2018 09:02 PM
It lives! It’s working 100% ok.
Thanks to this thread below.
http://www.hpmuseum.org/cgi-sys/cgiwrap/hpmuseum/archv006.cgi?read=12608
It just needed a little aluminum foil wrapped around the terminal leads.
Im using a shapeways plastic power pack with a copper dual coiled spring
Question, is there a more permanent solution for the terminal leads?
The aluminum foil falls off when the pack is pulled out.
I can solder, but dont want to mess up the 25c terminal leads and do it incorrectly.
RE: Hp25c - Maximilian Hohmann - 06-21-2018 07:53 AM
(06-20-2018 09:02 PM)dm123 Wrote: Question, is there a more permanent solution for the terminal leads?
I think the ideal solution would be to insert new silver rivets in place of the corroded ones. Some time ago I bought a bag full on eBay but unfortunately they are metric size and a tiny bit too small to make good contact. So double check before ordering...
RE: Hp25c - Massimo Gnerucci - 06-21-2018 11:39 AM
(06-20-2018 09:02 PM)dm123 Wrote: Question, is there a more permanent solution for the terminal leads?
SCNR