+- HP Forums (https://www.hpmuseum.org/forum)
+-- Forum: HP Calculators (and very old HP Computers) (/forum-3.html)
+--- Forum: General Forum (/forum-4.html)
+--- Thread: Calculator Design Series #2 (/thread-11872.html)
Calculator Design Series #2 - SlideRule - 11-29-2018 04:22 PM
While reviewing my library for HP-65 Programmable Calculator material(s), I ‘rediscovered’ Calculator Design Series #2, Hydraulic Design of Improved Inlets for Culverts using programmable calculators HP-65 (1980 OCT) 147 pages. The publication includes 20 programs with examples, equations, limitations etc. An extract from the INTRODUCTION …
The programmable calculator as a culvert designing tool offers many desirable features. Compared with the hand method, the calculator is more accurate, less time consuming, and eliminates all searching through charts and nomographs. In one quarter of the time it takes to design one culverts by hand, the designer could use the calculator to design the culvert, checking four or five different sizes to find the best one, while also evaluating several inlet configurations including both side- and slope-tapered inlets.
My efforts to locate a web repository are ineffective, so I intend to scan and submit the publication for inclusion in the museum document sets (flash drive-CD-archives): until then, any requests to post one of the twenty programs to the forums HP-65/67/97 Software Library?
BEST!
SlideRule
RE: Calculator Design Series #2 - SlideRule - 10-07-2024 12:19 PM
OK, finally located a link: Hydraulic Design of Improved Inlets for Culverts using Programmable Calculators, Hewlett-Packard (HP-65), FHWA, OCT 80, 159 pages
BEST!
SlideRule
ps: moderator, please move this post to the software section
RE: Calculator Design Series #2 - Thomas Klemm - 10-07-2024 01:19 PM
Quote:The procedure herein covers both box and circular pipe culverts and follows the culvert design methods presented in "Hydraulic Design of Improved Inlets for Culverts,''
Hydraulic Engineering Circular No. 13 (HEC 13), dated August 1972.
RE: Calculator Design Series #2 - Thomas Klemm - 10-07-2024 01:43 PM
This topic reminded me of an old thread: MANPIP
And indeed we find on page 39:
Quote:This depth may be determined by trial and error using a form of Manning's Equation:
\(Q=\frac{1.49}{n} A R^{2/3} S^{1/2}\)
RE: Calculator Design Series #2 - SlideRule - 10-07-2024 02:17 PM
OK; the post belongs in the HP-65 software thread, & then eventually in Calculator Literature URL? Since my original post was in this thread & didn't have a link to the HP-65 program listings, descriptions, etc., I provided a link, as promised.
BEST!
SlideRule