Arg on HP Prime - Printable Version +- HP Forums (https://www.hpmuseum.org/forum) +-- Forum: HP Calculators (and very old HP Computers) (/forum-3.html) +--- Forum: HP Prime (/forum-5.html) +--- Thread: Arg on HP Prime (/thread-15468.html) |
Arg on HP Prime - Plantarum - 08-15-2020 10:03 AM Dear fellow HP users, This may have been asked before or a stupid question, but I can't figure out where the ARG function is on the Prime. I have used HP 48 and 50 since they came out and after calculation, you could do right shift EEX to get the arguments back on the screen. Say 10 enter 5 + Answer 15 Richt shift EEX (ARG) will show 10 and 5 again. This is a very useful function and I can not find it on the prime. I like to use the calculator in RPN, because I am used to that, but in that mode the arguments are not automatically shown on the left side of the screen. Any help is much appreciated, Hubert RE: Arg on HP Prime - Stevetuc - 08-15-2020 01:22 PM (08-15-2020 10:03 AM)Plantarum Wrote: Dear fellow HP users, Shift Ans should do it. RE: Arg on HP Prime - Plantarum - 08-15-2020 10:05 PM Thanks, Sorted now. Was a bit hard to find after changing the command. |