+- HP Forums (https://www.hpmuseum.org/forum)
+-- Forum: HP Calculators (and very old HP Computers) (/forum-3.html)
+--- Forum: General Forum (/forum-4.html)
+--- Thread: how to open *.DIR? (/thread-17627.html)
how to open *.DIR? - dwesti - 10-27-2021 11:56 AM
from that one:
https://www.hpcalc.org/details/1059?
RE: how to open *.DIR? - Kiwi - 10-27-2021 09:23 PM
Just put DEMOS.DIR on the stack (level 1) of the HP48. Then enter: 'DEMO' STO.
Go to the DEMO directory (press VAR DEMO) and start the demos.
RE: how to open *.DIR? - dwesti - 10-28-2021 07:04 AM
yes, it works! thanks a lot
RE: how to open *.DIR? - dwesti - 10-31-2021 11:49 AM
one more question: how to open *.lib? Stack displays: Library<...>
RE: how to open *.DIR? - rprosperi - 10-31-2021 12:40 PM
(10-31-2021 11:49 AM)dwesti Wrote: one more question: how to open *.lib? Stack displays: Library<...>
Libraries can only be stored in Ports.
So, to store LIB123 in port-1, recall it to the stack and use:
:1:LIB123 STO
Note that any name can be used for the stored library.
Then, use [RS] [Library] to see all the stored libraries.
This is the 48GX, but the same applies for 49g, 50g, etc.
RE: how to open *.DIR? - dwesti - 10-31-2021 02:01 PM
thanks, it works
for Ripplev3 (https://www.hpcalc.org/details/8965)
I see Graphic 131x64, but I don't know how to display pictures
UPD: put 1 on stack, press [PICTURE]
RE: how to open *.DIR? - CMarangon - 11-02-2021 09:02 PM
Hello!
Take a look at:
https://area48.com/hp50/dirs.php