HP Forums
How to run binary file with the latest firmware - Printable Version

+- HP Forums (https://www.hpmuseum.org/forum)
+-- Forum: HP Calculators (and very old HP Computers) (/forum-3.html)
+--- Forum: HP Prime (/forum-5.html)
+--- Thread: How to run binary file with the latest firmware (/thread-8483.html)

How to run binary file with the latest firmware - wangchong01 - 06-10-2017 09:04 AM

I have found the three-party firmware, but it doesn't work with the latest firmware. The calculator just went black after I had flashed the firmware into it. So how can I run a binary file with the latest firmware?

RE: How to run binary file with the latest firmware - akmon - 06-10-2017 05:22 PM

Excuse me, where have you found the three- party firmware?. Thank you.

RE: How to run binary file with the latest firmware - wangchong01 - 06-12-2017 05:04 AM

(03-16-2017 07:43 PM)Jean-Baptiste Boric Wrote:  Technically, you can install https://github.com/boricj/ripem and run bare metal ELF binaries, but it's just a proof of concept at this point.

But indeed, you can't run native programs with the official firmware.

http://www.hpmuseum.org/forum/thread-7957.html

RE: How to run binary file with the latest firmware - Jean-Baptiste Boric - 06-12-2017 08:00 AM

Looks like I'll have to dust off my disemboweled HP Prime. Actually, I'll have to write a hardware-level emulator first because I'm not going back to the "blind debugging and flashing under Windows" endless cycle ever again.

Can you open a GitHub issue with:
  • hardware revision (DVT, HW-A or HW-C) ;
  • firmware version ;
  • description of symptoms ;
  • link to this thread ;
so that I can keep track of this?

RE: How to run binary file with the latest firmware - wangchong01 - 06-13-2017 08:55 AM

I have open an issueSmilehttps://github.com/boricj/ripem/issues/3