Prime hangs in terminal screen

[Maro]

I have produced a few pages of program output, printed to the terminal screen. When the program ends on the terminal screen or when I switch to the terminal screen later by pressing the ON and DIVIDE buttons, the Prime freezes completely after trying to go to the last page of the terminal screen by SHIFT, DOWN.

In this case the hourglass shows up and only ON SYMB helps to reanimate the Prime. Is this a known issue, or just a problem with my Rev A (V0.032.6030)?

When I go to the end of the terminal screen by pressing DOWN multiple times, a fast scroll to the top by pressing SHIFT UP works fine. Within programs both SHIFT UP and SHIFT DOWN work fine too.

[Tim Wessman]

Was on the list. Thanks for the report.

[Maro]

Thanks Tim for the reply. Then I'll be waiting for the next firmware rev ...