Post Reply 
Function setup
12-26-2017, 04:39 AM (This post was last modified: 12-28-2017 11:40 PM by BryanPiguave.)
Post: #1
Function setup
Hi. Is it possible to change the plot setup using a command in the Function app?
I was working on a programme about LVE for chemical engineering and I wanted to change Xmin, Xmax,Ymin,Ymax. It would be great if these can be changed to share my results in this forum.

Thanks.


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
01-01-2018, 10:49 PM
Post: #2
RE: Function setup
The plot set up is accessible through app variables. This access is documented in the user guide.
Find all posts by this user
Quote this message in a reply
01-01-2018, 11:32 PM (This post was last modified: 01-01-2018 11:35 PM by StephenG1CMZ.)
Post: #3
RE: Function setup
If you wanted to do it as a command from Home or within a program, have you tried
Function.Xmin:=123?
(Where Function is the name of the App)

Stephen Lewkowicz (G1CMZ)
https://my.numworks.com/python/steveg1cmz
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)