HP Prime or HP 50g

[Claudio L.]

(07-13-2018 12:36 PM)Neve Wrote:  BTW, how’s the current state of development of that awesome newRPL for the 50g? Do you know?
Last time I checked it out was over a year ago. I myself couldn’t get along with it because of the remapping of the keys. I’m so used to the current keys and menus.
I wished I could get over it cause it’s truly awesome and lightning fast too!!!

I guess that's a question for me, it really belongs in another thread but... I'm taking a vacation on newRPL for a few months while I work on the Prime, in preparation for a future port of newRPL (there's a lot of work to be done before I can run newRPL ALONGSIDE the current firmware). The concept is that neither the Numworks port nor newRPL could replace the power of the full CAS in the Prime, so replacing it permanently doesn't make much sense to any user. My vision is not to replace the Prime firmware, but to allow multiple firmwares to run and be "switched" at will.
Now if you could switch between them simply by turning the calc off and back on, I see most users would have no reason to not have all 3 firmwares installed, which will benefit everybody.