HP Prime corrupting programs

[scorpio72]

Thanks a lot for the news about this very last firmware version, very welcome !

Unfortunately, after flashing this version and doing the same test scenario mentioned above, I observed the same symptoms and problems regarding RAM management (need reset to get back to 17Mb) and the flash memory area reserved for Lists and Programs is not protected and could result in programs getting corrupted and even crunched (from 110Kb to 108Kb for instance)

I had to format C: "9" reset for 3 or 4 times in order to get back to >17Mb RAM instead of 16.30Mb, and a state where the settings are saved when the calculator is turned off then on.
(when I checked the RAM and found >17Mb, I understood that the settings are able to be saved now)

Please, if HP Prime developers are reading this, please review this case and provide a fix that will make this calculator really perfect. A fix of this level will certainly ensure a very important stability needed by the users. This will be a really big fix and important step.

New version installed :
Software Version : 2.0.0.13865 (2018 07 06)
Operating system : V0.050.640
HW : C

Thank you