[50g] Assign VIEW to a key

[SammysHP]

Thanks for your suggestions!

(07-23-2018 05:36 PM)rprosperi Wrote:  The initial SysRPL book by Jim Donnelly, "Introduction to System RPL and Assembly Language", although written for the 48 series, is probably the best introduction/tutorial type text on SysRPL.

I'll start reading it as soon as possible, thank you. A HP 48G(X) is still on my wish list. Made my first experiences with HP calculators with Emu48 and later Droid48.

(07-23-2018 05:57 PM)DavidM Wrote:  A much simpler way to do this is to assign the following program to your preferred key:

Code:

« DUP SCROLL »

I already found SCROLL in the AUR, but was unsure about the performance of DUP (because VIEW isn't called in a high rate usually this wouldn't be a big issue, though) and if there are other differences between SCROLL and VIEW.

(07-23-2018 05:57 PM)DavidM Wrote:  If you haven't already found it, another great resource is looking through posts in the comp.sys.hp48 usenet newsgroup. The collected knowledge in that archive is immense.

Thanks, I've been reading there a lot for years., but often you do not find exactly what you need. Anyway I found many interesting things, although I was looking for something different.