Firmware Upgrade Woes

[Nick Taylor]

Hi Tim,

Thank you for your very fast reply!

I have left the updater running, and have unplugged, replugged several times.

I can’t see a way to switch the calculator off when the update fails, so I pin-reset it. If I hold down SYMB at this point, it restarts the updater on the calculator. I’ve tried replugging it at this point too, but the updater on the PC just sits there. I know the PC registers the rebooted calculator as it appears as a disk at that point.

Is there any way (command line switches?) to force the updater to send the second and third files without waiting?

I’m willing to try anything you suggest.

Thanks again,

Nick