HP Forums / HP Calculators (and very old HP Computers) / General Forum v / how to get "out of box" state

Post Reply 
how to get "out of box" state
10-02-2018, 09:33 AM (This post was last modified: 10-02-2018 09:34 AM by samo50g.)
Post: #7
samo50g Offline
Junior Member
 		Posts: 29
Joined: Oct 2018
RE: how to get "out of box" state
BartDB, thanks so much. according to your answer I assume I am done. So, yes, I have deleted everything except the three libraries.

I understand your answer as I did right with installing ROM 2.15 over "old" ROM 2.15 which was (I guess) "infected" with third party software. As you can see I have difficulties with understanding software architecture of these calculators. that's why I desperately ask for the confirmation of my logic.

BTW, I did reset (On, F3, F6) and in additon I also removed ALL batteries for 20 minutes and did not recover the memory, just to be completely clear.
Thanks.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
how to get "out of box" state - samo50g - 10-01-2018, 04:55 PM
RE: how to get "out of box" state - BartDB - 10-02-2018, 09:27 AM
RE: how to get "out of box" state - DavidM - 10-02-2018, 02:28 PM
RE: how to get "out of box" state - BartDB - 10-02-2018, 09:13 AM
RE: how to get "out of box" state - samo50g - 10-02-2018 09:33 AM
RE: how to get "out of box" state - BartDB - 10-02-2018, 10:14 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication