HP 45 Charger`

[Milanomike]

OK, need a bit of help here.

I'm finally back on my HP 45 charge unit.

I need the 400 uF cap, no issue and the 470 ohm resistor,no issue, but I also want to replace the zener diode next to the resistor.

The schematic from above says to use a 1N4002, but the diode i have in there only shows 23097 on it.

I'm not shrewd enough in searching around to determine if this is equivalent to a 1N4002 or is a 5.1 volt (or any voltage) zener diode.

So, any help is appreciated, if i can order tonight, i can pick up locally tomorrow and hopefully have my old 45 working again.

Thanks.

Mike