HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / Existing CAS commands --> Prime discussion

Post Reply 
Existing CAS commands --> Prime discussion
12-10-2018, 05:45 AM
Post: #51
John P Offline
Member
 		Posts: 219
Joined: Dec 2013
RE: Existing CAS commands --> Prime discussion
(12-10-2018 01:43 AM)Joe Horn Wrote:  
(12-09-2018 11:47 PM)John P Wrote:  There is no makevector command on HP Prime as described in the cascmd_en. I think I used it a while ago but, somehow it misteriously disappeared from HP Prime.

It was never included in Prime's vocabulary.

Probably not, but I think I used it after reading, a while ago, the cascmd_en. Now when I type makevector(1,2,3) nothing happens on my HP Prime with the latest firmware. Maybe you have different one.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Existing CAS commands --> Prime discussion - John P - 12-10-2018 05:45 AM



User(s) browsing this thread: 7 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication