HP-65 Financial Software request
|
01-09-2019, 09:51 PM
Post: #32
|
|||
|
|||
RE: HP-65 Financial Software request
Hi everyone, this is what actually happens :
Turn the calculator, Switch to W/PRGM, SST reveals the following code : 23 11 35 04 24 ... That should be the default code for LBL A loaded at the startup, right ? Then, I switch back to RUN and I read my magnetic card where I have recorded the code for CST, SEL and MAR (Cost, Sell and Margin from post #5), now if I switch to W/PRGM SST reveals the following code : 23 11 33 01 00 35 21 ... I have checked all the listing and it looks like this : LBL 23 A 11 STO 1 33 01 0 00 g x≠y? 35 21 RTN 24 g NOP 35 01 RCL 2 34 02 RCL 2 34 02 RCL 3 34 03 x 71 EEX 43 2 02 ÷ 81 - 51 STO 1 33 01 RTN 24 LBL 23 B 12 STO 2 33 02 0 00 g x≠y? 35 21 RTN 24 g NOP 35 01 RCL 1 34 01 1 01 RCL 3 34 03 EEX 43 2 02 ÷ 81 - 51 ÷ 81 STO 2 33 02 RTN 24 LBL 23 C 13 STO 3 33 03 0 00 g x≠y? 35 21 RTN 24 g NOP 35 01 1 01 RCL 1 34 01 RCL 2 34 02 ÷ 81 - 51 EEX 43 2 02 x 71 STO 3 33 03 RTN 24 LBL 23 E 15 DSP 21 . 83 2 02 CLx 44 STO 1 33 01 STO 2 33 02 STO 3 33 03 RTN 24 This IS the correct listing, in fact, if I switch again to RUN and I type : 40 A -> 0.00 50 B -> 0.00 C -> 20.00 The problem is when I try to execute it a second time, in fact, if I type now : 40 A I get 0.03 (which is 1/40 in DSP.2 mode) Somehow it looks like after the first execution is not returning at the beginning of the code, ready for a second run. If I switch to W/PRGM and I go after the LAST line of the code written from the forum this is what I find : 23 11 35 04 24 It looks like somehow the original code loaded at startup has been shifted at the end of the code read from the magnetic card. I must said that if after the first successful run of the code I press RTN then I can execute the code a second time with no problem. What am I missing here ? thanks again Alberto Edoardo & Alberto |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)