HP-35 Power Supply Waveforms

[albertofenini]

That is a good indication,
how much should be the value of the resistors that simulate the load ?
Should be connected between the Voltage point and ground, right ?

On the other hand, the guide that we use to repair the HP65 shows how to test PSU
off load, de-soldering cathode of CR2 and the anode of CR1 and
de-soldering the cathode of CR4
and the cathode of CR5 from the logic board, lifting them up, and solder them together

This means that good values should be available also off-load, right ?