USB power module and 41CL update

[MeindertKuipers]

Hi Diego,

I have the connectors, some with and some without the tabs. I also have some modules left that I think have limited commercial value. Maybe it would be nice to have the module housings printed with the tab more or less included, so more module connectors could be used. I think I have a total of 10-12 connectors available.

In case you consider to actually use my connectors, contcat me by mail or PM,

Regards from NL!

(03-25-2019 12:05 AM)Diego Diaz Wrote:  Hi Meindert,

Hope you're doing well.

Regarding the 3D printed module housings, I haven't had the chance to check one of those, but as long as they have the same internal dimensions and tabs to firmly retain the connector in place, it should be ok.

I assume that the connectors you have are remaining from your MLDL2K project. Do they still have the securing tabs? (These tabs have to be removed to install the connector in the Card Reader housing. As you know for sure :-)

Look forward to reading from you.

Best wishes.

Diego.