The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 795 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 795 errorHandler->error




HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / Digit Grouping, HP Prime G2

Post Reply 
Digit Grouping, HP Prime G2
09-05-2019, 08:02 PM
Post: #1
Thott Offline
Member
 		Posts: 53
Joined: Jul 2019
Digit Grouping, HP Prime G2
Hello,

I found that many programs did not run, when I select for the decimal point a comma as it is usual here in EU.
When I change it back to "dot"......no problem at all.

E.g.: https://www.hpmuseum.org/forum/thread-9708.html

With a comma as decimal point the program did not run and shows a syntax error, when it is checked.
With a dot as decimal point it runs without problems.

It seems that the selection of the digit grouping must be in compliance with the programming.

HP Prime G2, newest firmware


Attached File(s) Thumbnail(s)
   
http://www.dg8fbv.de
41CX, Card R., Barcode R., X-Function, X-Memory, Advntg-Modul,
HP41 Printer, 82200A Touchpad, 48GX black LCD, 50g, Prime G2
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Digit Grouping, HP Prime G2 - Thott - 09-05-2019 08:02 PM
RE: Digit Grouping, HP Prime G2 - Thott - 09-05-2019, 11:03 PM
RE: Digit Grouping, HP Prime G2 - Guido - 09-05-2019, 09:57 PM
RE: Digit Grouping, HP Prime G2 - Thott - 09-05-2019, 11:06 PM
RE: Digit Grouping, HP Prime G2 - Han - 09-05-2019, 11:13 PM
RE: Digit Grouping, HP Prime G2 - Thott - 09-05-2019, 11:27 PM
RE: Digit Grouping, HP Prime G2 - Thott - 09-06-2019, 10:42 AM
RE: Digit Grouping, HP Prime G2 - Thott - 09-09-2019, 03:47 PM
RE: Digit Grouping, HP Prime G2 - Tyann - 09-10-2019, 04:48 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication