HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Soldering and de-soldering station - advice required

Post Reply 
Soldering and de-soldering station - advice required
09-21-2019, 05:36 PM (This post was last modified: 09-21-2019 05:38 PM by Siegfried.)
Post: #17
Siegfried Offline
Member
 		Posts: 147
Joined: Jan 2014
RE: Soldering and de-soldering station - advice required
I recently bought a ZD-985 (from a Polish seller on EBay) and while it occasionally clogs up it still eases desoldering of multiple pins quite a lot. I have not tried it on a calc but 80´s homecomputers should be similar. I got a used Metcal for soldering but that seems to have been a lucky find as they don‘t seem to come up often.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Soldering and de-soldering station - advice required - Siegfried - 09-21-2019 05:36 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication