Post Reply 
a good code editor for HP Prime
11-20-2019, 03:59 PM
Post: #9
RE: a good code editor for HP Prime
Hi Frank,

I downloaded and installed what I thought was Code Editor 1.3 using the program list and it starts fine (get the little pop-up window) and I can define a new program shell. However, that is a far as it goes. When I try to edit it (or edit an existing program) I get the message "Error: Insufficient memory". I am running on a physical G1 calculator with most memory left (not too many items defined). Can it run on a G1? If so, what could I be doing wrong?

Thanks and take care, Steve
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: a good code editor for HP Prime - swagner53 - 11-20-2019 03:59 PM



User(s) browsing this thread: 5 Guest(s)