Post Reply 
Turning on a HP 41 with the HP IL module plugged
05-17-2020, 08:04 PM (This post was last modified: 05-17-2020 08:07 PM by Sylvain Cote.)
Post: #5
RE: Turning on a HP 41 with the HP IL module plugged
Check that the module contacts are clean and that they do connect correctly with the flex.
You may have a defective cable, a way to test this is to enter the following program and run it with a close loop.
Play with the cable to see if the tone stop or the beep interval becomes very long, if it is the case then you may have a semi-broken cable.
Code:
LBL "TSTIL"
LBL 01
AVIEW
TONE 0
GTO 01
END
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Turning on a HP 41 with the HP IL module plugged - Sylvain Cote - 05-17-2020 08:04 PM



User(s) browsing this thread: 1 Guest(s)