HP Forums / HP Calculators (and very old HP Computers) / General Forum v / HP42s first major program (Double Integral) Best way to approach?

Post Reply 
HP42s first major program (Double Integral) Best way to approach?
06-01-2020, 04:46 PM (This post was last modified: 06-01-2020 06:26 PM by DM48.)
Post: #36
DM48 Offline
Member
 		Posts: 128
Joined: May 2020
RE: HP42s first major program (Double Integral) Best way to approach?
Albert, thank you for posting that update. That is over my head but it allowed Werner to create a noticeably faster implementation of Bore on my DM42 and for that I am grateful to the both of you.

I have the "coupon" that was "tapped" from ductile iron pipe on my desk. I have always assumed, when flattened, it would be an ellipse. Is that correct?

*Update 1* I ran Werner's original Bore program on an authentic HP42s. It took approximately 30 seconds to complete. Will program in this new program to compare.

*Update 2* Reading closer through the program I found LSTO command. Guessing this is a local variable command not found on the HP 42s?
HP48GX, HP42s and DM42.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: HP42s first major program (Double Integral) Best way to approach? - DM48 - 06-01-2020 04:46 PM



User(s) browsing this thread: 20 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication