Search
Member List
Calendar
Help
HP Forums
/
HP Calculators (and very old HP Computers)
/
HP Prime 
/
G1/G2 Unit to Unit issues - Low Power msg & G1 cannot send to G2
/
G1/G2 Unit to Unit issues - Low Power msg & G1 cannot send to G2
|
G1/G2 Unit to Unit issues - Low Power msg & G1 cannot send to G2
|
|
06-07-2020, 03:21 PM
(This post was last modified: 06-07-2020 10:23 PM by cahlucas.)
Post: #1
|
|||
|
|||
|
G1/G2 Unit to Unit issues - Low Power msg & G1 cannot send to G2
Hi all,
The first problem concerns the battery status. When I connect a G1 to a G2, I get a message on the G2 that the battery is low, and that I have to recharge it as soon as possible. This is despite the fact that the G2 has recently been charged, and the battery indicator shows 100% when the calculator is not connected. Both the G1 and G2 have the latest firmware update. The second issue concerns some apps that are on the G1, not the G2. This concerns the Linear Explorer, Quadratic Explorer, the Elements and the Trigonometric apps. I would also like to have it on my G2. Unfortunately that did not work with the special cable from HP. The "SEND" button flashes briefly, but then disappears. What can I do about these problems? Have there ever been reports of these issues on this forum? I would like to hear from you what can be done about this. Sincerely, Karel. I use HP-16C, WP-34S emulator, HP-35s, HP-48GX, HP-50g, and HP Prime G2. |
|||
|
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)