HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Volume of a bead with square hole- Program approach?

Post Reply 
Volume of a bead with square hole- Program approach?
06-10-2020, 01:59 PM (This post was last modified: 06-10-2020 02:22 PM by DM48.)
Post: #14
DM48 Offline
Member
 		Posts: 128
Joined: May 2020
RE: Volume of a bead with square hole- Program approach?
(06-10-2020 01:58 PM)grsbanks Wrote:  
(06-10-2020 01:52 PM)DM48 Wrote:  How can I set my calc to RAD and back to DEG from within a running program. Would be nice to have the program change to RAD before running if necessary, and then back to whatever it was.

The DEG, RAD and GRAD commands in the MODES menu are programmable.

Thank you.
HP48GX, HP42s and DM42.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Volume of a bead with square hole- Program approach? - DM48 - 06-10-2020 01:59 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication