French assistance needed.
|
07-03-2020, 02:12 AM
Post: #12
|
|||
|
|||
RE: French assistance needed.
Thank you, this are the steps I mailed him:
1- connect your programmer to a USB port. 2- run the device manager, and check in properties if it has got the correct driver (ver. 3.3.11.152 from 12/03/2010) If the driver is ok then there shouldn't be any problem. Just note the assigned COM port number, and select it in the microbrn.exe "Port" menu. 3- If it is not, uninstall the device and mark the "remove the software" tag. 4- Disconnect the USB programmer, and run the Prolific Driver installer (v1210). 5- Restart your PC and connect the USB programmer again. 6- Check again in the Device manager which COM port number has been assigned as in step nr. 2- above. and run microbrn.exe. I don't use any 3rd party USB scan app. but I think the result should have to be the same. He has replied that the dirver still shows the yellow exclamation mark in the device manager listing... I'm running out of ideas... :-( In case this is becoming too specific for the "General forum" feel free to contact me by e-mail. Thanks again and best wishes. Diego. "Do not suppose, check it twice." |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 4 Guest(s)