French assistance needed.

[JMBaillard]

Hi Sylvain.

Thank you for this advice.
It completely solved the problem I had with Clonix.

I also have a problem with my HP50G & conn4x with Windows10(64bits):

First, I could not install HPcaalculatorUSBsetup
But I found on the web this method:

Step 1 – Download the Connectivity Kit
Download Link: http://www.hpcalc.org/hp49/pc/link/conn4x_english.exe
Step 2 – Install the Connectivity Kit
- Install the software downloaded in Step 1
Step 3 – Download the USB Drivers
- Download Link http://www.hpcalc.org/hp49/pc/link/hpcal...bsetup.exe
Step 4 – Install the USB Drivers
- In Windows XP / Vista / 7 simply run the EXE file downloaded in Step 3 to install
- On Windows 8/8.1/10, the USB Drivers will not install until Driver Signature Enforcement has been disabled. To do so:
1. Click the Start menu and select Settings.
2. Click Update and Security.
3. Click on Recovery.
4. Click Restart now under Advanced Startup.
5. Click Troubleshoot.
6. Click Advanced options.
7. Click Startup Settings.
8. Click on Restart.
9. The PC restarts, on the options screen pick 7) Disable driver signature enforcement.
10. Run the hpcalculatorusbsetup.exe file downloaded in Step 3 to install the USB drivers. NOTE: You will get a warning that Windows can’t verify the publisher of the software, you must choose “Install this driver software anyway”
Step 5 – Open the Connectivity Kit and Connect

Now, I can use conn4x to connect my HP48GX but it doesn't work perfectly,
more precisely:

When I click to connect the calculator ( with Xmodem server )

1-A few seconds later, it's disconnected
2-I reclick, it's disconnected again but with a message:
"Connection error
please check your connections"
3-Then I click on OK and the HP48 is automatically reconnected
and HOME (HP48) is displayed with all the folders too.

(Connect using has 2 possibilities: Auto & COM3 )
So, it finally works well but after 3 surprising steps !

>>> Contrariwise, with my HP50G, always the following results:

When I click to connect the calculator:

"Connection error
please check your connections"

If I click on OK, same message
I click again on OK, same message
I click again on OK, nothing !

( connect using has just 1 possibility: Auto
with WindowsXP, there was: USB calculator )

I also tried this ( found on the web ):

1-Open Device Manager.
2-Click on Action in the menu bar and select Add legacy hardware > Next.
3-Select Install the hardware that I manually select from a list (Advanced) and click Next.
4-Scroll down, then select Ports (COM & LPT) and click Next.
5-Select the Manufacturer accordingly and click Finish.

It added a COM PORT but this did not change anything for the HP50G.
( perhaps I didn't choose the right manufacturer ? )

Best regards,
Jean-Marc.