The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 795 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 795 errorHandler->error




HP Forums / HP Calculators (and very old HP Computers) / General Forum v / HP-67 stuck in scientific (DSP 0) mode

Post Reply 
HP-67 stuck in scientific (DSP 0) mode
07-17-2020, 08:58 AM (This post was last modified: 07-17-2020 08:09 PM by tribidouille.)
Post: #1
tribidouille Offline
Junior Member
 		Posts: 26
Joined: Jul 2020
HP-67 stuck in scientific (DSP 0) mode
Hello members,

I might have done a unwanted manipulation while trying to write a program into my 67 or have put it into a mode that I can't exit any more.
After having taken a look into the manual I don't really understand this mode. I am no very deeply involved into maths I have to say.

The problem:
It look like if I would be stuck in base 9 with no decimals. On the right of the display, I read the tenth, on the left, the units from 0 to 9. After nine, the left part resets to zero and the right part increases.

"clx"
[Image: jyUfZ21.jpg]

"2"
[Image: mS5G1DA.jpg]

ENTER
[Image: rolMsAJ.jpg]

"2" + "8" +
[Image: VVyGk9W.jpg]

Sure one of you will tell me in one second where I am blocked but I am sorry to admit my gap.
Thanks

edit: change thead subject to better reflect the situation
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP-67 stuck in scientific (DSP 0) mode - tribidouille - 07-17-2020 08:58 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication