12C Platinum vs. 48GX vs. 50g (Speed Test)
|
10-01-2020, 02:17 AM
(This post was last modified: 10-01-2020 08:36 AM by JDW.)
Post: #13
|
|||
|
|||
RE: 12C Platinum vs. 48GX vs. 50g (Speed Test)
(10-01-2020 01:45 AM)Allen Wrote: Eric's apt reply, first posted by Xerxes has both the keystrokes for a counting loop I suggested, as well as exact key sequences for HP 12c queens problem. Thanks. I had examined that super-long document twice before, but after reading your reply, I went through it super slow and found the relevant section, which I shall post below so nobody else need read through that long document for 12C related info... HP-12C HP-12C Platinum HP-12C ARM ---------- 01 Clear Σ 02 8 03 STO 0 04 RCL 1 05 RCL 0 06 x<=y 07 GTO 58 08 1 09 STO+1 10 RCL 1 11 STO n 12 RCL 0 13 STO Nj 14 1 15 STO+2 16 RCL 1 17 STO 3 18 1 19 STO-3 20 RCL 3 21 x=0 22 GTO 04 23 STO n 24 RCL Nj 25 RCL 1 26 STO n 27 Rv 28 RCL Nj 29 - 30 x=0 31 GTO 43 32 0 33 x<->y 34 x<=y 35 CHS 36 RCL 3 37 + 38 RCL 1 39 - 40 x=0 41 GTO 43 42 GTO 18 43 RCL 1 44 STO n 45 RCL Nj 46 1 47 - 48 STO Nj 49 x=0 50 GTO 52 51 GTO 14 52 1 53 STO-1 54 RCL 1 55 x=0 56 GTO 58 57 GTO 43 58 RCL 2 59 GTO 00 Now I need to know when to Press ENTER. Maybe that's clear to some people, but not to me. I can complete steps 01 to 06 without pressing ENTER, but I stop at step 07. Also what is step 27 “Rv”? No such button exists on the 12CP! Next, what does STO with a + or - before the number mean? I press CHS before that number?? Next, isn’t “33 x<->y” incorrect? I see a white marked “x><y” key and then “x<=y” in blue, but there is no x<->y key! All said, I don’t know how to key this in. Do you? |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)