HP Forums / HP Calculators (and very old HP Computers) / General Forum v / HP50G - Help using OPENFIRE (GREYSCALE) with SYSRPL

Post Reply 
HP50G - Help using OPENFIRE (GREYSCALE) with SYSRPL
10-30-2020, 06:29 PM
Post: #1
JeffB Offline
Junior Member
 		Posts: 15
Joined: Jun 2019
HP50G - Help using OPENFIRE (GREYSCALE) with SYSRPL
I would like some help using OPENFIRE with just SYSRPL commands assuming this is possible

Based on the instructions I have tried this

#20 #20 MAKEGROB INVGROB
#3
ROMPTR 6CA 002 ( ->4GRAY )

but just get a grob on the stack with vertical lines
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP50G - Help using OPENFIRE (GREYSCALE) with SYSRPL - JeffB - 10-30-2020 06:29 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication