Controlling program exit

Threaded Mode | Linear Mode

Controlling program exit

11-18-2020, 05:55 PM

Post: #15

cahlucas Offline

Member

Posts: 157
Joined: Mar 2016

RE: Controlling program exit

(11-17-2020 09:08 PM)Jacob Wall Wrote: I just drag & dropped the .hpprgm file over to the Programs folder of a connected G2 calculator and everything worked completely fine.

Are you on Windows or Mac?

Dear Mr. Wall,
My CK runs on Mac. Perhaps is that the problem, but I refuse to run Windows. Sincerely, Karel.

I use HP-16C, WP-34S emulator, HP-35s, HP-48GX, HP-50g, and HP Prime G2.

« Next Oldest | Next Newest »

Messages In This Thread

Controlling program exit - cahlucas - 11-13-2020, 05:03 PM

RE: Controlling program exit - Stefan_Titan2944A - 11-13-2020, 09:19 PM

RE: Controlling program exit - cahlucas - 11-13-2020, 10:16 PM

RE: Controlling program exit - Stefan_Titan2944A - 11-14-2020, 10:00 AM

RE: Controlling program exit - Stefan_Titan2944A - 11-14-2020, 10:58 AM

RE: Controlling program exit - Han - 11-13-2020, 10:44 PM

RE: Controlling program exit - cahlucas - 11-13-2020, 11:08 PM

RE: Controlling program exit - Jacob Wall - 11-14-2020, 04:31 PM

RE: Controlling program exit - cahlucas - 11-15-2020, 07:55 PM

RE: Controlling program exit - Jacob Wall - 11-15-2020, 10:58 PM

RE: Controlling program exit - cahlucas - 11-17-2020, 05:31 PM

RE: Controlling program exit - StephenG1CMZ - 11-15-2020, 10:08 PM

RE: Controlling program exit - Jacob Wall - 11-17-2020, 09:08 PM

RE: Controlling program exit - cahlucas - 11-18-2020 05:55 PM

RE: Controlling program exit - Han - 11-17-2020, 10:15 PM

RE: Controlling program exit - Han - 11-18-2020, 09:41 PM

RE: Controlling program exit - cahlucas - 11-20-2020, 01:59 AM

RE: Controlling program exit - Han - 11-21-2020, 04:53 PM

RE: Controlling program exit - cahlucas - 11-21-2020, 11:54 PM

RE: Controlling program exit - Han - 11-30-2020, 01:57 AM

RE: Controlling program exit - cahlucas - 11-30-2020, 10:01 PM

User(s) browsing this thread: 1 Guest(s)