Post Reply 
NutStudio for MacOS to display register contexts
12-07-2020, 02:25 AM
Post: #9
RE: NutStudio for MacOS to display register contexts
(12-07-2020 01:02 AM)Massimo Gnerucci Wrote:  
(12-07-2020 12:14 AM)mfleming Wrote:  My understanding is that the lack of Windows support is due to a lack of support for the source language that NutStudio is written in (Haskell). We're stuck with a workaround for now Sad

Really?

Not that I have to complain too much, but this missing support is unfortunate, since pre-built binaries for the 3 platforms were available at least up until version 2.1.1.

Oh well, thanks anyway Hakan!

GHC/Haskell that I use is well supported on Windows. The problem is money. I need to buy Windows in order to build NutStudio and I cannot justify spending the money on something I would only use for this purpose.

However, there is one minor glimpse of hope in that I have a rather weak machine with a non-registered but legal copy of Windows. It was never activated in time (there was a time limit in doing so for that machine). I plan to set up a virtual Windows 10 on my main Linux box (Windows 10 iso can apparently be downloaded free of charge). Then I will see if I can coax Microsoft into allowing me to activate and use that license for the virtual machine.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: NutStudio for MacOS to display register contexts - hth - 12-07-2020 02:25 AM



User(s) browsing this thread: 2 Guest(s)