Post Reply 
FRAM71 and RS-232
02-07-2021, 09:01 AM
Post: #3
RE: FRAM71 and RS-232
moons ago, I "upgraded" a 82164A internally with an USB232R serial-to-USB module. they seem to be obsolete now.
connections between the FTDI and 82164A's UART (Rockwell R6551AP) are just 4 wires: TX, RX, VDD, GND. supply from USB is sufficient, so no more need for the wall adapter.

leaving 82164A's configuration unchanged after power-up, the PC-side USB COM-port is configured as 9600 N8 1 XON/XOFF.
a PRINTER IS 1 and then printing "1234567890ABCDEF" in a loop yields about 410 Bytes / sec.

iirc, setting the HP82164A and the PC to 19200 baud also works, but i don't remember the transfer speeds.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
FRAM71 and RS-232 - Dave Frederickson - 02-06-2021, 09:20 PM
RE: FRAM71 and RS-232 - J-F Garnier - 02-06-2021, 10:10 PM
RE: FRAM71 and RS-232 - Hans Brueggemann - 02-07-2021 09:01 AM
RE: FRAM71 and RS-232 - J-F Garnier - 02-07-2021, 09:50 AM
RE: FRAM71 and RS-232 - Hans Brueggemann - 02-07-2021, 10:02 AM



User(s) browsing this thread: 1 Guest(s)