HP-IL device Seal s5801c

[PeterP]

(02-07-2021 03:58 PM)Dave Frederickson Wrote:  I thought that if the connector could be identified as being used with a particular interface standard that that would help. Here're the specs on the connector:
https://b2b.harting.com/ebusiness/en_us/...9061486901

The connector is a DIN 41612 series connector as used by various bus standards including VME.
https://en.wikipedia.org/wiki/DIN_41612
However, this particular connector is not used with any bus standard I'm familiar with although I'm pretty sure it's one used with Eurocards.
https://en.wikipedia.org/wiki/Eurocard_(...uit_board)

Dave

Dave, I don’t think this is the correct connector. Mine has three rows of equal length prongs, not just two. Does that change anything from your assessment? I will take a pic of the bottom of the PCB and post in case that is helpful.

Clearly worried now that this is DC powered, not AC...