HP-IL device Seal s5801c

[PeterP]

(02-07-2021 03:37 PM)Erwin Wrote:  

(02-07-2021 03:22 PM)Dave Frederickson Wrote:  I think this is a bad idea. Typically, industrial chassis that accept modules, like this one, provide DC power from a separate module plugged into the chassis backplane.
The transformer connections are probably the output to the AC motor.

Dave

Interesting thought. Yes this could be a possibility. To be on the secure side it would be necessary to look a the layout of the platine backside too, so we could describe the main components for the power part and the logic circuit. It‘s an interesting project.
Erwin

Please see the backside attached. The transformer says : Primary 220V, Secondary 2 x 6V.
One the pins of the Primary side goes to the middle TO and from there to one torroidal, the other TO goes to the other Torroidal. The Second pin of the Primary side seems to go towrds the fuse.

Any of this helpful? Does it spit out 220V AC to drive a motor with a 6V input or is it the other way around? I am so confused...