FRAM 71: Impact on start time

[Sylvain Cote]

(02-14-2021 09:03 AM)Michael Lopez Wrote:  I find it takes ~ 4 Seconds for the unit to start from the time I press the On button.

(02-14-2021 09:52 AM)KimH Wrote:  Could it be that you should use OFFIO (disable IL) and see if it starts faster. The IL always makes the machine slow, if no active devices are attached.

Kim is right, the HP-IL module is trying to configure the loop at power on but is failing to so.
The long startup time is the HP-IL module waiting to receive his configuration messages back.

Code:

OFF IO     → disable all HP-IL communications, including power on loop configuration
RESTORE IO → enable HP-IL communications and try to configure the loop
             if nothing is plugged then it fails with the message: "HPIL ERR: Loop Broken" with the same timeout delay as power on