Help on (emu48) HP49-50G: IOPAR "corrupted"

[cdmackay]

(02-28-2021 01:37 PM)rprosperi Wrote:  I can't say if this is the default value, but on one of my 50g's, IOPAR is set as follows:

{115200 0 0 0 3 1}

The 50g AUR (pp. D4–D5) confirms those are the default I/O parameter settings.

Those settings correspond to:

115200 baud rate
0 no parity
0 XOFF/XON software flow control disabled for receive
0 XOFF/XON software flow control disabled for transmit
3 3-digit cyclic redundancy check for SEND
1 translate 10 (LF) to/from 10 & 13 (LF & CR)