Mark Hoskins' HP 97 printer idler gears

[Jonas Sandstedt]

Hello,

I have read in the forum that gears that possibly can be used as idler gears for the HP-97 can be bought in the EU from GHW-Modellbauversand, see
http://www.ghw-modellbau.de/
The product that should fit is "Spur gear module 0,3 brass - 30 Z", articel number 753030. According to what I have read, the inner diameter has to be increased to fit.
I have bought some, but have not tested yet, so please note that if you buy it is at your own risk.
Luckily, they are fairly inexpensive.

best regards
Jonas