Search
Member List
Calendar
Help
HP Forums
/
HP Calculators (and very old HP Computers)
/
HP Prime 
/
Making a new Program from Connectivity Kit crashes G2
/
Making a new Program from Connectivity Kit crashes G2
|
Making a new Program from Connectivity Kit crashes G2
|
|
06-29-2021, 10:02 AM
Post: #3
|
|||
|
|||
|
RE: Making a new Program from Connectivity Kit crashes G2
No crashes here, following your steps.
I wrote only a simple minimal test program, and used "Send to class" to transfer this program to the virtual calcluator. Syntax check etc. was done on the virtual calculator, because this is not supported in connectivity kit. |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Making a new Program from Connectivity Kit crashes G2 - matalog - 05-30-2021, 08:25 PM
RE: Making a new Program from Connectivity Kit crashes G2 - matalog - 06-29-2021, 09:12 AM
RE: Making a new Program from Connectivity Kit crashes G2 - Thomas_Sch - 06-29-2021 10:02 AM
RE: Making a new Program from Connectivity Kit crashes G2 - matalog - 06-29-2021, 11:14 AM
RE: Making a new Program from Connectivity Kit crashes G2 - Thomas_Sch - 06-29-2021, 12:15 PM
RE: Making a new Program from Connectivity Kit crashes G2 - Hammonds - 11-16-2022, 08:01 AM
RE: Making a new Program from Connectivity Kit crashes G2 - jte - 01-06-2023, 06:39 AM
RE: Making a new Program from Connectivity Kit crashes G2 - rootboy - 02-21-2023, 10:24 AM
|
User(s) browsing this thread: 2 Guest(s)