HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / I'm a noob

Post Reply 
I'm a noob
12-07-2021, 02:51 AM
Post: #12
Jacob Wall Offline
Member
 		Posts: 163
Joined: Dec 2013
RE: I'm a noob
(12-06-2021 10:54 AM)JPV99 Wrote:  I have a G2 with version 2.1.14597 (2021 11 25). And the App I want to run would be EEC Solver I found a thread on this forum: https://www.hpmuseum.org/forum/thread-11...EEC+Solver
It's not necessary for me to be able to run it but It just bugs me that I can run It on an emulator that's meant to work the same way the real one does, and I can not do it on the real thing.

I was able to install it on a G2 with the same firmware and it appeared to run as expected. I did not go beyond a few test operations to create a new circuit, as this subject is not something I am familiar with.

Maybe try a factory reset? I find it is a necessary thing to do sometimes as for whatever reason the calculator can start 'acting up'.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
I'm a noob - JPV99 - 12-02-2021, 09:20 AM
RE: I'm a noob - rprosperi - 12-02-2021, 05:02 PM
RE: I'm a noob - JPV99 - 12-02-2021, 06:40 PM
RE: I'm a noob - Jacob Wall - 12-03-2021, 01:19 AM
RE: I'm a noob - JPV99 - 12-03-2021, 08:51 AM
RE: I'm a noob - toml_12953 - 12-03-2021, 10:41 AM
RE: I'm a noob - JPV99 - 12-03-2021, 10:46 AM
RE: I'm a noob - Jacob Wall - 12-03-2021, 01:38 PM
RE: I'm a noob - JPV99 - 12-03-2021, 03:28 PM
RE: I'm a noob - Jacob Wall - 12-03-2021, 10:50 PM
RE: I'm a noob - JPV99 - 12-06-2021, 10:54 AM
RE: I'm a noob - Jacob Wall - 12-07-2021 02:51 AM
RE: I'm a noob - JPV99 - 12-16-2021, 02:52 PM
RE: I'm a noob - toml_12953 - 12-16-2021, 04:27 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication