Evaluate function with parameter

[Guenter Schink]

(02-15-2022 06:09 PM)StephanP Wrote:  I've also tried to use the Connectivity kit to copy your code into the Virtual Calculator, but there too I was not able to work out how to do this.

I've tried this code also without success on the virtual Prime. After I created the F-Param, pushed <SHIFT> <1> to open the Program catalog. Then opened the "F-Param"

First observation: there is no block like this

Code:

//START()
//BEGIN
// MSGBOX("START");
//END;

The screen is empty. So nothing to delete. Copied the proposed code completely into the virtual Prime. <Check> Reports "Error: Syntax Error". Leaving the editor with <Esc> is accompanied by the message "Syntax error in program line 1". That line is 'START()'
@Didier: perhaps we need to check the Sw-Version.

Here it is "Build: 2.1.14592(2012 6 9)

Günter