[BUG-GUIDE] when transfering mViewer GX programs

Threaded Mode | Linear Mode

[BUG-GUIDE] when transfering mViewer GX programs

07-08-2014, 10:59 AM (This post was last modified: 07-08-2014 10:59 AM by critor.)

Post: #4

critor Offline

Member

Posts: 60
Joined: Jul 2014

RE: [BUG-GUIDE] when transfering mViewer GX programs

Hi,

It's not you - there are memory leaks in the HP-Prime.
So you are limited in the number of huge programs you can run in a row.

Do not try to edit those huge programs.
If there is an error or a bug, just reset the calculator and rerun the last program.

« Next Oldest | Next Newest »

Messages In This Thread

[BUG-GUIDE] when transfering mViewer GX programs - alexzkter - 07-07-2014, 08:27 PM

RE: [BUG-GUIDE] when transfering mViewer GX programs - debrouxl - 07-08-2014, 05:00 AM

RE: [BUG-GUIDE] when transfering mViewer GX programs - alexzkter - 07-08-2014, 08:21 AM

RE: [BUG-GUIDE] when transfering mViewer GX programs - critor - 07-08-2014 10:59 AM

RE: [BUG-GUIDE] when transfering mViewer GX programs - alexzkter - 07-08-2014, 02:03 PM

RE: [BUG-GUIDE] when transfering mViewer GX programs - eried - 07-08-2014, 06:18 PM

RE: [BUG-GUIDE] when transfering mViewer GX programs - critor - 07-09-2014, 12:39 PM

User(s) browsing this thread: 1 Guest(s)