HP Forums / Not HP Calculators / Not quite HP Calculators - but related v / newRPL - Updated to build 1510 [official build remains at 1487]

Post Reply 
newRPL - Updated to build 1510 [official build remains at 1487]
05-27-2022, 05:48 AM
Post: #208
Claudio L. Offline
Senior Member
 		Posts: 1,886
Joined: Dec 2013
RE: newRPL - Updated to build 1497 [official build remains at 1487]
(05-16-2022 12:05 PM)spiff72 Wrote:  A bit off topic from the 39gs discussion, but has there been any progress or advancement in the development of newRPL for the Prime (G1)?

I am trying to decide if it is worth searching for a used G1 (I have a G2 currently) to dedicate to newRPL...

Very little time to spare lately... newRPL development has slowed to a crawl. Touchscreen drivers are working for all models of the Prime G1 (turns out different hardware revisions had 2 different touchscreen chipsets, who knew...).
So now it can recognize up to 2 fingers... last time I touched the code I was trying to figure out what to do with touch... other than touching the on-screen menu items which is the obvious choice.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: newRPL - Updated to build 1497 [official build remains at 1487] - Claudio L. - 05-27-2022 05:48 AM
Navigating through sub-menus - Gilles - 05-13-2023, 11:31 AM
It's a mystery to me... - Klaus - 11-27-2023, 12:24 PM



User(s) browsing this thread: 10 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication