HP Forums / HP Calculators (and very old HP Computers) / General Forum v / 67 Mag card with both program and data

Post Reply 
67 Mag card with both program and data
06-01-2022, 10:53 PM
Post: #3
Dave Britten Offline
Senior Member
 		Posts: 2,334
Joined: Dec 2013
RE: 67 Mag card with both program and data
Yup. Just have a program that's no more than 112 steps on one side, and data from only the primary registers on the other.

I think I've read some tips/articles in PPC Journal that mentioned having more steps/data in memory when writing the card so that you still get one side of the card prompting you with "CRD" to pass the other side through.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: 67 Mag card with both program and data - Dave Britten - 06-01-2022 10:53 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication