Post Reply 
Building a Casio RP-33 clone, working with Zebra strips
06-16-2022, 05:51 PM
Post: #24
RE: Building a Casio RP-33 clone, working with Zebra strips
(06-16-2022 01:44 AM)Jeff_Birt Wrote:  
(06-15-2022 08:30 PM)Nigel (UK) Wrote:  I’ve just received the RP-33 clone, V1.1, ordered from Tindie. It appears to work properly, both in a FX-880P and as an RP-8 in a FX-730P. Brilliant!

Nigel (UK)

Are you the chap who just did the install video? I have had one report of an FX-880P taking a few tries to get the RP-33 Redux installed and working. Other than that all have worked. Not knowing the factory build tolerance on all applicable models it is a bit of a educated guess to get the size just right.

No video from me, I’m afraid! On the pair of machines I tried there was no real problem getting it to fit, so long as I kept the screws loose until all were going in. Resetting each machine made the memory visible.

Nigel (UK)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Building a Casio RP-33 clone, working with Zebra strips - Nigel (UK) - 06-16-2022 05:51 PM



User(s) browsing this thread: 7 Guest(s)