The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 795 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 795 errorHandler->error





Post Reply 
HP48GX Boot Loop - help
08-04-2022, 04:27 PM (This post was last modified: 08-04-2022 04:29 PM by wmundstock.)
Post: #1
HP48GX Boot Loop - help
Hi All.

Have anyone seen an old HP 48GX with a bootloop problem like this?
Any suggestions? Basic troubleshooting steps did not work.

https://youtube.com/shorts/gmMI6rGGFSU

What I tried.
Hidden RESET Button - turns the calculator off, then when I turn on it goes back into that loop.

After resetting I tried:
1. On + C
2. On + A + F
3. On + D

Remove batteries, etc all tried.. No luck.

Note how when I hold the on key, it speeds up the beeps. Almost seem like a short... maybe capacitor damaged?

Any advice is welcome!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP48GX Boot Loop - help - wmundstock - 08-04-2022 04:27 PM
RE: HP48GX Boot Loop - help - cruff - 08-04-2022, 05:11 PM
RE: HP48GX Boot Loop - help - Kiwi - 08-05-2022, 10:19 AM
RE: HP48GX Boot Loop - help - wmundstock - 08-05-2022, 11:28 AM
RE: HP48GX Boot Loop - help - shoman24v - 08-05-2022, 12:22 PM
RE: HP48GX Boot Loop - help - dmh - 08-05-2022, 12:50 PM
RE: HP48GX Boot Loop - help - wmundstock - 08-05-2022, 01:55 PM
RE: HP48GX Boot Loop - help - franz.b - 08-06-2022, 02:45 PM
RE: HP48GX Boot Loop - help - wmundstock - 08-08-2022, 07:22 PM



User(s) browsing this thread: 3 Guest(s)