What am I doing wrong

Threaded Mode | Linear Mode

What am I doing wrong - HP42 (DM42)

10-04-2022, 02:18 AM

Post: #2

rprosperi Offline

Super Moderator

Posts: 6,672
Joined: Dec 2013

RE: What am I doing wrong - HP42 (DM42)

Some things to try, in this order, checking if it's fixed after each step:

1. Shift-SETUP-2 Load Clean State

2. Insert a paper-clip into the reset hole on the back side

3. Reinstall the latest DM42 firmware, available here:
https://forum.swissmicros.com/viewtopic.php?f=16&t=3187

If none of these steps solves the problem, it is likely a h/w issue.

How old is this DM42?

--Bob Prosperi

« Next Oldest | Next Newest »

Messages In This Thread

What am I doing wrong - HP42 (DM42) - rkumetz - 10-03-2022, 04:32 PM

RE: What am I doing wrong - HP42 (DM42) - rprosperi - 10-04-2022 02:18 AM

RE: What am I doing wrong - HP42 (DM42) - Didier Lachieze - 10-04-2022, 04:37 AM

RE: What am I doing wrong - HP42 (DM42) - rprosperi - 10-04-2022, 12:22 PM

RE: What am I doing wrong - HP42 (DM42) - rkumetz - 10-04-2022, 12:38 PM

RE: What am I doing wrong - HP42 (DM42) - Thomas Okken - 10-05-2022, 05:07 AM

Swiss Micros Support - rkumetz - 10-04-2022, 12:42 PM

RE: What am I doing wrong - HP42 (DM42) - rprosperi - 10-05-2022, 02:02 AM

User(s) browsing this thread: 2 Guest(s)