HP Forums / HP Calculators (and very old HP Computers) / General Forum v / HP41CX - Naive' question - "Current File"

Post Reply 
HP41CX - Naive' question - "Current File"
12-17-2022, 03:15 PM (This post was last modified: 12-17-2022 03:44 PM by J-F Garnier.)
Post: #8
J-F Garnier Offline
Senior Member
 		Posts: 1,002
Joined: Dec 2013
RE: HP41CX - Naive' question - "Current File"
I believe (but that I don't really remember) that it have been fixed in the revision 1C of the module for the 41C/CV, and so in the 2D revision of the 41CX X-F too.
This also applies to the other bugs of revision 1B, see the addendum, sorry I can't put a link due to TAR (That Archaic Rule).

The reason I remember so well the 1B bugs is that I was a bit disappointed when I bought the expensive X-F module at the time and discovered the addendum inserted with the manual. Such bugs for such an expensive module...

J-F
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: HP41CX - Naive' question - "Current File" - J-F Garnier - 12-17-2022 03:15 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication